![]() ![]() I didn't notice any change in the car's performance whilst this was going on, even when maneuvering around the roundabout.When active regeneration finished I was still cruising at 55mph. to regenerate 2009-2015 volkswagen tdi golf jetta passat with vcds Having. Except where the engine speed dropped between minutes 16 - 19 when I was maneuvering a roundabout, you can see that exhaust gas temperatures remained between 650-700☌ throughout active regeneration. Downpipe assembly with diesel particulate filter for the 2010-2014 Jetta TDI. Similarly, soot mass continued to fall for a couple of minutes after the end of active regeneration at the 27 minute mark.So the whole active regeneration process took only 13 minutes from start to finish. However it was another 2 minutes before calculated soot mass in the DPF (thick red line) began to fall. DPF Regeneration can be done in 3 ways: 1) Passive regeneration while driving. It was only a couple of minutes later (at 14 minutes) when active regeneration began.Once active regeneration was initiated it took less than 30 seconds for the exhaust gas temperatures to jump to about 650☌. I observed the engine coolant temperature from the gauge on the dash and it wasn't until around the 12 minute mark that normal operating temperature (90☌) was reached. 30 ml Particle Filter Oil Ash Volume 23.4 Particle Filter Carbon Mass (spec.) 7.2 Particle Filter Carbon Mass (meas. I checked a couple of months ago and its gone up. DPF self-cleaning AUDI B7 3.0 TDI V6 233Hp Quattro Tiptronic. Exhaust gas temperature (thin orange line) is steady between 250-300☌. With VAG-COM\VCDS you can check the Ash/Carbon content of the Diesel Particulate Filter (DPF). Audi A4/A5/Q5 B8 Wypalanie DPF podczas jazdy -VCDS- prodedura/ DPF regeneration - audi a4 dpf. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |